Deviceways

Switch or relay

Sonoff THR316

Contribute

Projects for this device

Replacement firmware

Use a DS18B20 sensor and relay as a local thermostat in Home Assistant.

How to get started

Start with the matching ESPHome device configuration, set your Wi-Fi details and install it through ESPHome Device Builder. Initial conversion uses device programming access; later ESPHome updates can use Wi-Fi.

Setup
replacement firmware; initial programming connection, then OTA
You’ll need
Matching device configuration and attached sensor, where applicable.
Open device guidedevices.esphome.io
Original project esphome.io
Build
Build firmware from the device configuration.
Sources
Replacement firmware

Use local relay control and the sensor functions in the Tasmota device template.

Applies toFirmware: Matching Tasmota build; source does not pin one release

How to get started

Use the THR316 guide to install the matching ESP32 Tasmota build, then apply its device template.

Setup
serial firmware installation and device template
You’ll need
Exact supported device and matching module/template.
Original project tasmota.github.ioInstallation guide templates.blakadder.com

Hardware details

Security

Saved scan

No device-specific advisory matched our saved CVE research.

Check security advisories for this device · CVE.org