Deviceways

Switch or relay

Sonoff Mini Relay

Contribute

Projects for this device

Replacement firmware

Control the relay locally from Home Assistant, including the connected wall-switch input.

How to get started

Start with the matching ESPHome device configuration, set your Wi-Fi details and install it through ESPHome Device Builder. Initial conversion uses device programming access; later ESPHome updates can use Wi-Fi.

Setup
replacement firmware; initial programming connection, then OTA
You’ll need
Matching device configuration and attached sensor, where applicable.
Open device guidedevices.esphome.io
Original project esphome.io
Build
Build firmware from the device configuration.
Sources
Replacement firmware

Control the relay locally through a web page or MQTT, including its external switch input.

Applies toFirmware: Matching Tasmota build; source does not pin one release

How to get started

Use the Mini’s documented DIY-mode upload route, then configure the matching module in Tasmota.

Setup
DIY-mode network firmware upload
You’ll need
Exact supported device and matching module/template.
Original project tasmota.github.ioInstallation guide tasmota.github.io

Security

Saved scan

No device-specific advisory matched our saved CVE research.

Check security advisories for this device · CVE.org