Switch or relay

Shelly 1PM Mini Gen3

Projects for this device

Replacement firmware

Create local smart-home controls and automations using the device’s documented configuration.

Start with the device configuration, add your network settings and build the firmware. Use the first-install route specified in that device’s guide.

Setup: Custom configuration + firmware installation
You’ll need: The documented board version and pin configuration; a serial adapter or another supported installation route.

Open device guidedevices.esphome.io

Sources

Replacement firmware

Add the compact relay to Apple Home, with power measurement supported by the project.

Applies toFirmware: Gen3; stock prerequisite documented as 2.0.0

Follow the project’s stock-firmware prerequisite, install Shelly-HomeKit over the local network and pair it with Apple Home.

Setup: network firmware upload (OTA)
You’ll need: Exact supported model/generation; stock prerequisite specified by the project.; Replaces stock firmware; Shelly Cloud and MQTT are not included.

Setup: Check the exact Shelly model/generation and upstream stock-firmware prerequisite.
Limitations: Shelly Cloud and MQTT are not supported by this firmware. Temperature/humidity measurement requires the documented AddOn/sensor hardware where indicated.
Configured features: Power measurement
Limitations: Shelly Cloud and MQTT are not supported by this firmware.
Limitations: Temperature/humidity measurement requires the documented AddOn/sensor hardware where indicated.